Procedure to modify Payouts for Standard MC700-CC token changerUpdated 25 days ago

MC700-CC Token Changer Programming Procedure

New Payout Configuration

Bill Acceptor

• $20 Bill = 12 Tokens

Credit Card Selections

Programming Instructions

1. Configure Accepted Bills

1. On the EF module, press the Right Arrow until you reach "Bills Accepted Settings."
2. Press the Down Arrowand answer:
   • Yes for $20 bills
   • No for all other bill denominations

2. Set the $20 Bill Payout

1. Press Exit.
2. Press the Left Arrow until you reach "Bill Vend Settings."
3. Press the Down Arrow until you reach the $20 bill payout setting.
4. Press Clear to remove the current payout.
5. Enter 12 for the new token payout.

3. Program Credit Card Payouts

1. Press Exit.
2. Press the Left Arrow until you reach "Selectable Vend Settings."
3. Press the Down Arrow to access each button setting.
4. For each button:
   • Press Clear to remove the existing token value.
   • Enter the new token payout according to the table below.

4. Exit Programming Mode

1. Press Exit twice until "Main Menu" appears.
2. Programming is now complete.

Verification Testing

Bill Acceptor Test

• Insert one $20 bill.
• Verify that 12 tokens are dispensed.

Credit Card Tests

Using the test credit card, perform one transaction for each selection:

• $80 → Verify 60 tokens
• $60 → Verify 40 tokens
• $40 → Verify 25 tokens
• $25 → Verify 15 tokens

Count the tokens after each test to confirm the correct payout.

Request Credit for Test Transactions

After testing is complete:

1. Call Nayax Support: 410-666-3800.
2. Provide the Nayax serial number located on the back of the card reader.
3. Explain that management performed four test vends:
   • $80
   • $60
   • $40
   • $25
4. Request a credit for the total test amount of $205.